cap site
   
 

OTHER TELEVISION

Connect your TV, hold button (PROG-) and (VOL-)

* * *

SABA

Processor ST90R91. Chassis unit - ICC10.
Method 1: Connect the TV, holding the blue button 5
seconds
remote.
Method 2: Connect the TV set, hold button (PROG-) and
(VOL-).
Holding the button 8 seconds.
Exit the menu - POWER OFF

* * *

ITT, Seleco, Saba, Telefunken

. STEREO PLUS chassis. To enter the service mode push
Buttons:
MUTE, OK, TV. Record changed settings with OK
perform.
Exit: TV

* * *

SALORA.

28N8S Model (EUROSTEREO 2B-F chassis, ZC410929P processor). To
entry into service mode you need to press on the remote control combination
subsequent key: - / -, MENU, TV (the last button should
hold down during 1 s). The combination of almost fit
to
all other modifications apparatus Salora 28xxx, and Salora
25xxx.

* * *

SALORA

7190, 6390, MV4000, 24101 852 SAT SOLI, 882 SAT SOLI, PL14, 885
SAT
SOLI CCU-SALO-07 processor (CCU20XX), M1shassi.
Sequence
(C) (*) (O / V) (#) (M), out - (!)


* * *

SALORA 5575SFN,

28T7, ST92T93protsessor STEREO PLUS, chassis.
The sequence (i) (M) (P)
Exit - (TV)

* * *

SALORA DIGIVISION 63..2, 71..2, 2..N6

NES3- ... NES2- .. processor, EUROSTE REO-1 chassis.
Sequence (- / -) (MENU) (TV) - 1 sec.

* * *

SALORA

Processors TVPO2066-A24, TVPO2065-DO1
Jumper contacts in the remote control 23 and 15 SAA1250 a jumper
19 contacts
and 14 SAA1250 in the remote control. If not included in the menu at once, you should
Additionally jumper pins 21 and 11 in the SAA1250 remote control.
Exit - (AV)

* * *

Sanyo CE28SW01,

VECO chassis, U99.190-07.
OM8363H / n3 / 4 CC6616 VATXMO processor.
There DK and SECAM, when connected.
Entry into service: go to the menu and press
9301posledovatelno.Vyyti

  • Zero button.


* * *

Sanyo. C28WK1N (A8-B chassis).

Hold the MEMORY button on the unit, press on the remote control


 
Tags | Site map | Copyrights
Copyright В© 2012 service-mode.com