cap site
   
 

OTHER TV

pressing the button repeatedly VT following table will appear.
SET-UP VIDEO GEOM
xxx 123456789 Configuration
Note: entry into service mode possible in the absence of
SCART
what some signals. To exit the stand-by button click.

* * *

CONTINENTAL CT1412.

The TV processor ST6375 installed. To enter the menu
sales need key P + P on the front panel of the unit
holding
Power Switch connected.

* * *

Daytek. DCT-2062-S.

Push the button on the remote control DISPLAY, MUTE, SLEEP, FUZZY. Then
click
DISPLAY or SLEEP, and the unit will enter the service menu.

* * *

Chassis CTS AB.

SAA5531PS / M4 / 0657 processor, RC2143 remote.
RESISTOR IS NEAR THE PROCESSOR WITH SERVICE inscriptions. AND ITS Unsolder
BUTTON
I + PRESS
OP21 -03
OP22-08
ZAPOMNIT- INST
PROBABLY WILL REPLACE IF filter

  • And IS BACK sealed SECAM and DC.


* * *

Chassis E9 (SDA5255-052 + TDA884x)

Entry into service: TV On, from Standby mode laborer
exit and
within 5 seconds. Press series "TV", "i", "STOP". (Well, not
secret
this).
Joining with Mak Maxi 2002:
Code = 1273.
"TV" = Rec / Erase
"I" = << / RADIO
"STOP" => / LNB
in the bottom two rows of all the buttons that teletext and Vydac.
Shift + MODE = Menu Picture
Shift + H / V = ??Menu Sound
This is how I, for speed of someone (myself often mudohayus).

* * *

ELEKTA CTR-2145, DTV21F4,

LC863320A processor videoprots. LA76810A.
Entering service: hidden button press (PROD) on the remote control from the
Vol +
Right, it - switching mode menu. chip
SC7461pulta -103
(The ends 2 and 15)
chip LC7461 console (the ends 2 and 16)

* * *

ERISSON S14, ERISSON 2120 or ERC 21NI60 3S10shassi


, ST92185BN4B1 / PBI 3S10B processor: -ENG / RUSS, STV2248C
videoprots :.
Entrance to the service menu:
Press the Menu-then AV - then ANAL
OK - choice of settings.
PP - out of service.

* * *

ERRISON 2102, 2103,

S3P8849XZZ-AQB9 processor.
Bridging of contacts 2 and 4 socket CN601. (GND and ADJUST)


 
Tags | Site map | Copyrights
Copyright В© 2012 service-mode.com