cap site
   
 

PHILIPS

Try on the remote control code 062596 and press MENU . TV switches to SAM, adapts to the desired channel (image , on what will become adjust ) buttons to select the channel number translation service on the menu - the cursor buttons on the remote control , up / down - election points, left / right - adjust , return to selection adjustment - MENU button .
Exit the service menu varied by leaving settings - off TV remote.
As told to remove the barrel did not work (no corresponding settings in the CM menu adjustments horizontally). Value raster alignment and vertical linearity corrected .

***

TV PHILIPS 21PV288/58S

, service menu, which is the entrance?
PHILIPS 21PV288/58S Video two , I would like the procedure of entering the service menu, and the likelihood that produces what point is very important channels to reset the starting condition.
Synchronously press on STOP ( on the remote ) and PLAY ( TV panel ) for more than five seconds. Exit - to put pressure on Standby ( on the remote ) .

***

TV Philips 29PT9008/12, chassis EM2E_AA

, how to get out of the service ?
Not run . When connecting and tried to start a second later disconnected and the LED blinks quickly . Was a bad contact on the panels of the kinescope . Now run , the screen on the left side at the top of "SER T", and at the bottom on the right side "Service Default".
Tell me how to throw a television in the ordinary mode ? This , I think, he stands in the service menu .
When you connect the secondary still occurs . When I disconnect from the remote TV , it is disabled , but a few seconds later he started again .
Perhaps before you who yuzanul , and threw jumper SDM? Try to get in and out of the service menu , input and output jumper.
I go to the service and get out with the remote control code 062596 and click i.
Beside two inscriptions memory SAM.SDM have to be severed.

***


***


***

Plasma TV PIONEER PDP-434PE

the receiver in

TAGS:

 
Tags | Site map | Copyrights
Copyright В© 2012 service-mode.com