cap site
   
 

Rekord

Table of Contents Table Op byte second options
EYE - 0 - Having eyes "golden"
VG - 1 - Personnel protection . Is present in the absence of VGT points ( see Table . 1)
AVL - 1 - Connect AVL
LDS - 1 - Connecting Loudness
BKS - 1 - Connecting blackstretch function " stretching " of black
HP - 0 - Presence headphones
IFIt - 0 - Time Polling IFI, 1 - 3 cycles , 0 - 1 cycle ,
ATST - 1 - Connecting Autotest
The values ??for the tuner options Table 3
Recorded values ??tuner
BL BH BU
UV1316 MK2, MK3 "PHILIPS" 01 02 04
KS-H- 148 "SELTEKA" 01 02 04
Tuner f. "Golden Dragon" 01 August 2

 tuner

2 times the "display"


***


***

entrance into the service menu

TV ROLSEN C29R25T.


Ingredients: processor TDA9352PXN 1.1g, memory 24C16, TDA8359, TDA7057, STV8216, TDA4605.
Found " in the duty room to put pressure on the menu bar , and pull it out button on the remote control 0"


***

Not recorded in the service menu of the device Rolsen C1440

Ingredients: processor TDA 9381PS/N3/1/1730, firmware P81 v2.0.
Please killed settings , IF 38 was IF38.9.
TV portrayed with snow and noise due to the shifted IF . Log into the service menu translation unit in standby mode , and then , holding the pressured "Menu" button on the front of the TV to press the 0 button on the remote control .
All specifications are changed , as described in the service manual , described on the site Rohlsen , but how to get out and save the changes , do not know - tried to turn the television off after the change and connect - svetodiodik blinks on the front panel of the TV , and the entrance is likely only in the service.
Tried too - sitting in the service mode , push the " 9 " on the remote and then - the " Volume + " or " volume - ". After a few seconds on the raster appears Pxx V2.xx message , and under it - the inscription «ready». Recording no ...
Taste it and holding the push button on the remote control "TV" and turn off the unit from the mains.

TAGS:

 
Tags | Site map | Copyrights
Copyright В© 2012 service-mode.com