cap site
   
 

FUNAI

  • check the correct operation of the function SEARCH (search )

If , in spite of a decent signal , no TV set , repeat the procedure with the options specified otherwise : OPTION 5 - OFF
( connected) and OPTION 6 - OFF ( disabled).
Get out of the service: to put pressure on the TV or turn off the TV remote control .
 HANSEATIC

***



Similar - GRUNDIG M70- 580 , M82- 100 , M70- 100 , M95- 100 . Chassis CUC1860, CUC1880, CUC1835, CUC1890. Processor control panel SDA30161 square (pay TV on the wall side ) .
ROM 24S16 and 27C512 , TDA4605, FEATURE BOX ( on main board )
TDA9080, TDA8145, TEA8172, TVS , Remote TP661 TOP, multiplier K536 = (HRT- 402 ) HRT- 906.
push and hold the button (i) on the remote control , hold for 5-10 seconds . This picture may ignite mono (stereo) . If you have any tips - OK , get into - GRUNDIG Info Center,
then in the Service programme
SERVICE MODE on the line to press (OK) ( 8500 ) .
Getting in geometry mode options menu - AUX, there is preservation.
Remember to adjust the Service , you need to pin 7 SDA3526 close to the body .

***

TV Grundig ST70- 300/8 , chassis CUC1837 as protection against access to remove .

COMPOSITION OF CHASSIS : CPU - SDA6000, memory - 24C02 Reset - MC33164 SMPS.
naughty kids with remote control handles played on the menu
Now when you turn on the protection of access highlights , the service menu 8500 (9300) does not start up .
Tried button (VOL +), (VOL-), then (CH-), (CH +)?
Or by holding R / C button to include ...
TV requires to enter the four-digit code after the code 7038 immediately gives more additional three stars to enter the code 580.


***

TV GRUNDIG ST 70-2003

C7chassis. BEKO.
ZX8.190- 17.
Enter the service mode : Menu button and the code is 8500 .

***


***

TV Grundig / Lenaro Model 82 Flat MFW82- 5510/8 Dolby

. Log into the service menu.


 
Tags | Site map | Copyrights
Copyright В© 2012 service-mode.com