cap site
   
 

HORIZONT

adjustment.
5.2.9 Trapeze
Press ? , ? To vertical lines , especially the line,
located at the edge
image are parallel to both sides of the tube .
Check and reconfigure the control TRPEZ,
if an adjustment was inappropriate after the committed
other geometrical adjustment.
5.2.10 Parabola
Press ? , ? To vertical lines at
close to the edges of the image are
parallel to the vertical sides of the tube without bending to the left
or right side of the screen . Check and
reconfigure the control PARAB, if an adjustment was
unsuitable after the other committed
geometrical adjustment.
5.2.11 The upper corners
Press ? , ? To vertical lines located in
the upper corners of the image ,
steel vertical and parallel to the vertical sides of the angular
CRT . Check and re-adjust
adjustment U.COR, if an adjustment was inappropriate after
how committed other geometric
adjustment.
5.2.12 lower corners
Press ? , ? to the vertical line located at
the bottom corners of the picture
steel vertical and parallel to the vertical sides of the angular
CRT . Check and re-adjust
adjustment L.COR, if an adjustment was inappropriate after
how committed other geometric
adjustment.
5.3 Adjustments video
Shift the program with a test pattern for geometric
adjustments to the program
color bars for video adjustments. Press the green button to
entry into this group. Select the items with
Use the ? , ? , After selecting the control to adjust it to the
Use the ? , ? . to save the
settings, press the «OK SELECT». Switch to a different group
Use the color keys . To exit the
this menu, press the «MENU».
5.3.1 Adjusting the white balance
Apply the test signal " white box " to the antenna input .
Configure all analog control
on average , and set RGn, GGn, BGn 80 if
necessary. Use a color analyzer for
color temperature control (X, Y). Select RGn and BGn by
buttons ? , ? . Use the ? , ?
change the values ??: X = 285 +10, Y = 10 to 293 color analyzer .
Set the adjustment values
PRf, GRf, BRf 62 ( permanently) .
5.3.2 Delay luminance field
Apply the test signal " color bars ". Select Y D


 
Tags | Site map | Copyrights
Copyright В© 2012 service-mode.com