cap site
   
 

HORIZONT

amplitude at
defined below , which can be seen on an oscilloscope , using
the "+" ("-" )
remote control :
standards for chassis 12.5 BG, DK, I: 630mVpp 20mVpp;
Chassis for 12.5 standarta LL: 450mVpp 20mVpp;
standards for chassis 12.5 BG, DK: 630mVpp 20mVpp;
Chassis for 12.5 standarta LL: 450mVpp 20mVpp;
Chassis for 12.5 standarta I: 500mVpp 20mVpp;
1.4 Adjusting the tuner
Set the service mode . Select the title of TUNER.
TUNER SHARP & ALPS
PHILIPS
P.SONIC
TEMIC
broadband
UHF only
Paragraphs " Broadband " and " Only UHF " are only valid for
12.4 chassis .
AV2 NO: one SCART
YES: one interface SCART + AV (RCA) on the front panel
CLR.S PAL
PAL / NTSC: SECAM is detected automatically
SND.S BG
I
BG + DK
TEXT DEFAUIT: Teletext
FASTEXT: Fastext
1.5 Geometric configuration
Enter the service mode . H.POS to the horizontal position .
V.HEI for
vertical resolution . LNRTY for vertical linearity .
S.COR to set the S-
correction.
1.6 Adjustment of the accelerating voltage
Enter the service mode . Select the line SCRN. Click "
+ " (" - " )
the remote control. At the bottom of the screen will appear white horizontal line .
Adjust the accelerating
potentiometer level horizontal line so that
it was only slightly
visible.
1.7 Setting the white balance
Enter the service mode . Select and set up G.CUT 128 .
Adjust
R.CUT and B.CUT setting to end . Select and configure
R.DRV and B.DRV
for white balance. Exit the service menu.
1.8 Pre-installation service menu item values
The following values ??are average values ??and can
change
Depending on the type of tube and chassis.

2 . Adjusting the Convergence
Note , before adjusting the information the TV must be
included at least
15 minutes.
2.1 Adjustment of the information in the center of the screen
1. Apply the test chart in the form of a mesh field
gENERATOR
signals.
2 . Adjust the brightness and contrast for good
picture.
3 . Adjust the two tabs of a 4-pole magnet to change the angle
therebetween ,
Align the red and blue vertical lines in the center of the screen .
4 . Turn both protrusions at one and the same time, retaining and red


 
Tags | Site map | Copyrights
Copyright © 2012 service-mode.com