cap site
   
 

HORIZONT

Output in the techno - menu button - "AV", and the output in the TV mode button
"TV". The adjusted values ??are stored automatically .

***

model STV 660,661

Connect your TV with the " Network" in the closed pre-
SHTST contacts on the control XN10 point. after preheating
tube to press the "Menu " (SL)
Select the desired option bytes using the " R +", " P " and
adjustment of the "+" , "-".
Exit service button "TV" Set Values
stored automatically .

***

model STV690

push the button on SB1 SHTST and hold before the
PM "PW" or " Parabola " . The call control button bytes
"Status" () on the remote control is made .
Exit from the "Tools" mode button "TV". The set values
automatically remembered .

model CTV676

1. Jumper on SHTST -676 terminals 1 and 2 control points XN11.
2 . While in standby mode, press on the remote user
sequentially
"Status" ( ) , then the "SL", then "off . Sound" ( ) and " duty
mode " ().
To save the results in the " TV Setup " to press "OK."
Return to the previous menu with the " TV" .

***

model STV670

When the unit is turned off on the remote or front panel push
button "AV" and ,
holding it , click the "Network" turn on the TV . Button "AV"
hold up
the appearance of glowing raster. Message on the screen IF38, 0AFC3
should appear that
indicates the inclusion of the "Tools" mode . In the absence of illumination
Raster soft spin on TDKS adjustment " accelerating " in
upward to achieve the glow of a pattern on the
screen.
Select the desired option bytes using the " R +", " P " and
adjustment of the "+" , "-".
Exit service button "TV". The values
installed automatically saved .

***

model CTV664 ( 11AK - 19shassi )

1. On the remote user to press the blue button , then 4 , 7,
2 , 5.
To store the values ??of all the adjustments needed after leaving the
" Service" mode to transfer the TV to standby mode .

***

model CTV664M ( AK30 chassis )

1. Button on the remote user "SL" click , then 4 , 7, 2 , 5.


 
Tags | Site map | Copyrights
Copyright В© 2012 service-mode.com