cap site


Table 1
Default value
Picture tube 21 "
Picture tube 20 "
Picture tube 14 "
VL 34 34 34 34 34
VS 25 25 25 25 25
VA 43 43 43 43 43
HS 36 36 36 36 36
SC 10 10 10 5 5
Mode SVC-2 (Fig. 3)
FP 18
NP 72
SP 55
SV 55
Fig. 3
In this mode, the regulated 5 parameters: FP (FM-tuning decoder, NP (tuning NICAM-decoder), SP (setting SCART), SV (audio level adjustment SCART), MAXVOL (volume control). Recommended values for these parameters are as follows: FP - 18, NP -72, SP - 40, SV - 55. MAXVOL parameter can be changed in the range of 1-100.
Mode SVC-3
In this mode, there are two options: Option 1 (Fig. 4) and Option 2 (Fig. 5). 5 correspond to each option parameters are presented in Table. 2 and 3. Buttons 0-9 can enter the appropriate data Option.



1. Preparing to configure the deviation
1) In the SVC, click the - button yellow.
If the remote access controller does not have the yellow button, use the button under the Channel Down (PR E) button.
And then, the deviation of the adjustment OSD (SVC1 mode) will be displayed.
2) Press the channel up / down to trying to function
3) Press the Volume up / down to adjust the data.
VL (Vertical linearity)
Adjust so that the boundary between the upper and lower half is in agreement with the geometrical center of horizontal transmission.
VA (Vertical amplitude)
Adjust so that the circle of digital model of the circle can be located in an effective PPC screen.
SC (West Vertical Correction)
Adjust so that the distances between a horizontal line must be the same.
VS (Vertical displacement)
Adjust so that the horizontal center line of a digital circle pattern in accordance with the geometric center of horizontal transmission.
HS (horizontal position)
Adjust so that the vertical center line of a digital model range
According to the geometric center of the vertical transmission. EW (width)
To adapt to this digital model of the circle looks like an exact circle.
EP (East-West Parabolar)

TAGS:, ,

Tags | Site map | Copyrights
Copyright В© 2012