cap site
   
 

LG

Adjust so that the middle portion of the far left and right vertical line looks like parallel with vertical lines of transmission.
EC (East-West Coner)
Adjust so that the vertical line on all 4 corners
The screen looks parallel with the vertical lines of transmission.
ET (East-West trapeze)
Adjust to the length of the horizontal upper line the same with the bottom horizontal line.

***

LG MC-991A

MC-991A.
Simultaneously press OK on the remote control at the TV and OK. Hold the button for about 10 seconds.

***

LG MC-991A, PC-33B, CK-20F84, KF-15FA9S

MC-991A.

Simultaneously press OK on the remote control at the TV and OK. Hold the button for about 10 seconds.

***

RSZZV.

Press and hold the SVC at a special console. Or on the remote control, performed on a chip SAA3010, jumper pins 1 and 11 of the chip. OUTPUT: TV

***

PC-58A.

Simultaneously press OK on the remote control at the TV and OK. Hold the button for about 10 seconds.

***

CK-20F84.

To enter the service mode needs a special service panel, but you can with the help of a staff. To do this, close the leads 10 and 17 of the encoder chip in the console.

***

KF-15FA9S.

Candy bar: Enter the service mode for a given chassis - the control board of the push-button station output signal R58 {} + shorted to ground at the same time press the (OK) Remote control - after entering the ground connection can be removed. Suitable for monoblock series KF-15-20-21Pxx

LG-2


***

LG MC-993A

1. Preparing to configure the deviation
1) In the SVC, press button yellow.
If the remote access controller does not have the yellow button, use the button under the Channel Down (PR U) button.
And then, the deviation of the adjustment OSD (SVC1 mode) will be displayed.
2) Press the channel up / down to trying to function
Adjustment.

TAGS:, ,

 
Tags | Site map | Copyrights
Copyright В© 2012 service-mode.com