cap site
   
 

SAMSUNG

3. Check the data in the service
4. Adjust RG, BG in Factory Mode.
4-4-7 (B) low light RESTRUCTURING
1. Automatically done during high light adjustment.
2. 4-4-8 center convergence adjustment
1. Warm up for at least 20 minutes.
2. Place the two tabs 4 pole magnets change the angle between them. Cast red and blue vertical lines in the center of the screen.
3. Adjust the brightness and contrast to clearly define the picture.
4. Install two pairs of tabs 4 magnets, and change the angle between them. Put on the red and blue vertical lines in the center of the screen ..
5. Turn both tabs at the same time, keeping a constant angle, and put the red and blue horizontal lines in the center of the screen.
6. Install two pairs of tabs 6 magnets to put the red and blue lines on the green. (Changing the angle affects the vertical lines, as well as rotating magnets affects the horizontal line.)
7. Repeat adjustments 2 ~ 6, if necessary.

Models SC 6271 WP.

To enter the service menu, press the button or press HIDDEN very quickly following sequence of buttons on the remote
Control: STANDBY, P.STD,
HELP, SLEEP, POWER ON.

Service mode TV "Samsung CK6271, SK7271."


Before entering the service mode, the TV is switched by remote control (RC) in the standby mode

Samsung

(Stand-by).
Service mode is activated in two ways:
Х click on the remote control buttons in the following sequence: Video Prefer Х A / V Х Sleep Timer Х Power; press the Hidden Service, hidden on the remote.
Then in the upper left corner of the TV screen will display FACTORY.
Service mode has three sub-modes: Х? Major adjustments (Main adjust mode);
Х? Adjustments delay luminance signal (Luminance delay control mode);
Х? White balance (White balance control mode).
FACTORY mode is canceled by pressing the button Hidden Service, or by pressing the power off.
Adjustment in the service mode


To move from the service mode submode adjust the basic settings, press the Status.


 
Tags | Site map | Copyrights
Copyright © 2012 service-mode.com