cap site
   
 

SHARP

on the TV, connect the AC button. Yield: (MENU).

* * *

CS Chassis

. Holding the button (CH +) and (VOL-) to
TV panel, turn the unit on the network button. Yield: (MENU).

* * *

CW100 Chassis

. Keys uriderzhivaya (CH +) and (VOL-)
on the unit, connect the TV network tumbler.
Yield: (MENU).

* * *

D3000 Chassis

. Push down on the S1401 switch
Housed in RWB-B module. Exit: Push repeatedly to S1401.

sharp 4


* * *

DA50W SHARP

SERVICE Adjustments
All the adjustments required for this gear to be made
Service menu other than G2 and alignment.
• ADJUSTMENT? G2
1. Apply the reference signal.
2. Set the contrast ratio to type 80/100 and brightness
to 40/100.
3. Connect the oscilloscope with a red cathode and adjsust G2, to
read
145V on the waveform.
NOTE:
The oscilloscope must be adapted to the vertical
television
Sweep and synchronized with the signal video.
• The service menu
This menu function was introduced to help with the settings of the
adjustments which can vary within certain limits.
To use the service menu:
1. Connect the test signal model in the slot antenna.
2. Push the power switch to "off".
3. Press the volume down and channel up buttons and network
switch to "turn on" at the same time.
Necessary adjustments can then be made from the Control
Remote control.
The only required buttons are as follows:
Up / Down-channel for traffic control in the options menu;
Up / Down-volume
used to make adjustments in said menu;
ON \ OFF
used to store new adjustment.
Menu control the following:
ALTER NVM VALUE.

  • TELETEXT MIX MODE CONTRAST.
  • TELETEXT CONTRAST.
  • OSD CONTRAST.
  • DVCO ADJUSTMENT (only PAL).
  • DVCO ADJUSTMENT (only NTSC).
  • AGC ADJUSTMENT.
  • AFT ADJUSTMENT.
  • OPC VALUE (not used in this model).

AUTOINSTALLATION ON / OFF.
To exit the service menu, push the switch to the network
"off".
Adjustment menu as follows:
horizontal:

  • Adjust HORIZONTAL SHIFT.
TAGS:

 
Tags | Site map | Copyrights
Copyright В© 2012 service-mode.com