cap site
   
 

SHARP

  • Adjust E-W WIDTH.
  • Adjust PIN PHASE.
  • Adjust PIN AMPLITUDE.
  • Adjust UPPER CORNER CORRECTION.
  • Adjust LOWER CORNER CORRECTION.

All amendments are based on the internal geometry of the exemplary
signal.
The procedure for amending the following:
horizontal:

  • Adjust VERTICAL AMPLITUDE.
  • Adjust S-CORRECTION.
  • Adjust VERTICAL SHIFT.
  • Adjust VERTICAL LINEARITY.

145V
0V

  • SERVICE SOFTWARE AND HEXADECIMAL

COUNTER DISPLAY: «SW ON XXXX SW OFF
XXXX HOURS ON XXXX

  • HORIZONTAL SHIFT.
  • EAST WEST WIDTH.
  • PIN PHASE.
  • PIN AMP.
  • UPPER CORNER CORRECTION.
  • LOWER CORNER CORRECTION.
  • VERTICAL LINEARITY.
  • VERTICAL AMPLITUDE.
  • S CORRECTION.
  • VERTICAL SHIFT.
  • RED GAIN.


* * *

DECO-4, DECO-5 Chassis

. DV5105H (DECO-4)
DV5107H, DV5135H and DV5132H (DECO-5)
1. Connect your TV to an antenna.
2. Adjust to the signal.
4. Merge momentarily jumper terminals 6 (service) and 2
(GND) connector CN1 on the board.
Note that the bridge is used in the same way as
passing switch contact.
5. You will see a 'SHARP Software Service Ver'.
Preference between the options implemented the Transfer button
programs.
Change data implemented buttons change the volume.
Standby button on the remote is used to store the changes.

sharp 5


sharp 6

Turn off the TV to exit the service.


* * *

EURO-DS1 Chassis

. Place a jumper between
end 2
(body) and the end of 6 (SV), are on board the TV signal. .
Exit:
press on the remote control (SKIP). Turn off the TV. Remove the jumper.

sharp 6

* * *

EURO-DS1 chassis. DV-5403S DIGITAL

. for entry
in the service
menu on the module you need a digital color short-lived
jumper
contacts "Tools" near the top of most chips
KM6264BLG-10. Exit - again these jumper pins.
Factory settings:
Sharp Service Mode V1.2 54035
Hor Phase Shift - 93
Blanking Phase - C5

TAGS:

 
Tags | Site map | Copyrights
Copyright В© 2012 service-mode.com