cap site


Vertical Phase - 35
Vertical Size - 0A B0
Vertical Simmetry-00 44
NVM Value - 00 AE
Croma-Luma Delay- A0
VCO Adjust - 3F F9
Cut-Off Red - 20
Cut-Off Green - 20
Cut-Off Blue - 20
Drive Red - AE
Drive Green - AC
Drive Blue - AC

* * *


FUNCTION service menu

1. Connect the test reference signal with the antenna jack.
2. Tune to this signal.
3. Unplug the receiver power switch.
4. Press the volume + and Channel - buttons on the receiver at the
same time.
5. While holding these buttons, turn on the network.
6. When the TV starts to be in the service menu.
7. Release the two buttons.
Use the channel up and down buttons to move
between the options.
Use the volume buttons to change the data.
The data is saved automatically when the service menu
out, or the machine is turned off.
Exit the service menu, press the standby button on the remote

sharp 7

Adjustment of Data within the NVM memory

To access the NVM memory, press the channel up button on the
remote control until the NVM setting is
reached. Note that the NVM address is shown in green and the NVM
value is shown in red.
Each of the NVM values are stored as a hexadecimal code, each
code comprises of two hexadecimal
numbers. Each of these numbers will break down into a four bit
binary code as in the example below.
Hex code A 5
Binary code 1010 0101
Button on remote to toggle Bit 7654 3210
In the example given above, the hexadecimal code is A5, the
binary equivalent is 1010 0101. The remote
control button to toggle each bit on or off (1 or a 0) is shown
below the binary code. Therefore to change this
to A6, remote control buttons 1, then 0 would have to be pressed.
Adjustment of the data within the memory NVM.
To access the memory NVM, click on the channel +
control until uregulirovka NVM appears. Note that
NVM address
shown in green, and the level of NVM are shown in red.
Each of the levels NVM stored as hexadecimal code, each


Tags | Site map | Copyrights
Copyright В© 2012