cap site
   
 

SHARP

to SERVICE MODE OPTION.
Once press the menu button again at the remote controller, EEPROM
will switch
back to SERVICE MODE 1.
• In the service option the user data establish as below,

SERVICE MENU.
Custom Data in the Utility menu.
If we SERVICE MENU 1 on, switch to the EEPROM data
operating data.
In addition, once press the menu button on the remote, EEPROM
switch
the service menu.
Once again, press the Menu button on the remote, EEPROM switch
back to the utility method 1.

* * *

PAL-A chassis. SHARP 14B-SC, 14D-SC, 14D-CM, 21D-CK1,
20B-SC,
CV-2132CK1

. Put the S1008 switch in position
mode service.

* * *

S3B chassis. SHARP DV-5450SC

. IX1492BM processor
SDA-20561.
To enter the service mode, you must connect the unit to the VIDEO
terminals
(6) and (2). After that, push the MODE button on the remote control.
there -SERV-
message. Then remove the jumper. The choice of adjustment CH- and CH +.

sharp 8

* * *

SC Chassis

. Holding the button (CH +) and (VOL-)
panel
TV switch the machine on the network tumbler. Yield: (STANBY).

* * *

SP41 chassis. SHARP 21FN1

. To enter the service
menu
need to determine the S1006 switch to the mode of service.
for
output on the screen modes alternately push the button SMODE,
S-NORM on the remote control, change the value on the control arrow keys
up and down.
The values of the menu system:
1. SERVICE MODE - mode service.
2. CUT OFF BKGD MODE - mode cutoff background.
3. H-CENT50 x / 15 - the horizontal offset (50 Hz)
4. H-CENT60 x / 15 - the horizontal offset (60 Hz)
5. RF AGC x / 63 -?
6. VCO x / 63 -?
7. SUB CON x / 127 - Contrast adjustment.
8. SUB COL x / 127 - color adjustment.
9. SUB BRI x / 127 - brightness adjustment.
10. SUB TIN x / 127 -?
11. SUB VOL x - volume adjustment
12. RF SUB VOL X / 127 - volume
13. BB CON x / 127 - Adjusts the contrast of blue background
14. BB BRI x / 127 - Adjusts the background brightness of the blue

TAGS:

 
Tags | Site map | Copyrights
Copyright В© 2012 service-mode.com